MOD COMP


MODCOMP_blueprint_E copy.jpg

The Mod Comp is designed for the logger who is looking for an edge when competing against HP riders, not only does it deliver here, but it’s also a great all rounder whether free surfing or mixing it at your club event or riding at a WSL level.

We incorporated a little edge and hip in the tail for turns, response and to give a little extra acceleration off the mark -allowing you to get some combo turns and rack up the points. The rocker has been tweaked, but mostly we left the board traditional providing good acceleration from mid board to enable section connection with out the dreaded HP hop. The Mod Comp has moderate nose width, 50/50 rails through to a down rail with a hard edge in the tail and a soft blended nose concave that leads to a slight panel V at the fin to an almost flat tail.

$1650

Sizes range 9’0” - 9’8” though we recommend going a little shorter than your traditional log. The Mod Comp comes standard with a clear glass job top and bottom, and 9mm T-band Stringer, though if you want to stand out in the heat, it can be customised with resin tints, glue lines, custom stringers and more. Be sure to specify in your order-form, or for a direct line call John on 0414577813

Glue Line (single or twin) - $50
Cedar Stringer - $50
High-density foam insert stringer -  $75
Volan or single colour tinted glassing top and bottom - $150
Glass in fin - $150